Anet A8 Printing problems

anet-3d

#1

Hello.

I have anet a8 I had purchased and assembled at the start of the week and i had received some printing problems but most of them have been resolved. All round the printer is good except for a few errors

When i was printing the stl file linked in the thread, I got these small gaps in the print as you can see, I am curious as to what can cause this.

There is also a inconsistency of it printing on the bottom. Also excess left on the gap in the middle of the piece which you can see in the photos

I printed this at 0.6 layer height with brim build plate adhesion and 20% infill. The filament is PLA and was printed at 200 degrees Celsius.
leftspoolholder.stl (39.1 KB)