Decided to tune my I3 plus as best I can and so wondering if Im on the right track.
Things I’ve done just done:
1.PID auto tune
2. Esteps calibration (this was off by 11mm)
3. LCD firmware upgrade.
4. Just about to install z brace mod.
5. Lowered jerk to 8.
That’s all I can think of really.
Does anyone have any recommended values for acceleration and jerk and what I should change to as per below screen shot? Im looking for quality rather than speed so any suggestions are welcome.
Also, my prints have always been slightly too large and ive had to scale to 0.99 in cura to make them fit, what would cause this, X/Y steps off? How would I check/calibrate those.
Current eeprom attached.