Hello all! New here and looking for someone who could answer something that I can’t find anywhere…

I just found out that the new software and firmware for the XYZPrinting Nobel 1.0 allows third party resins to be used with it. Only drawback is that the Auto-Fill is disabled, which is fine by me. Problems is, I can’t find anyone who has used third party resins yet. There are several parameters that can be adjusted and a new resin profile can be created with the new software. Unfortunately, I don’t know where to begin. Anyone here has any advise or maybe able to point me in the right direction? Thanks in advance. :slight_smile:

Did you fine an answers to over come the lack of auto fill