Hello everyone, I’ve been looking around at printers lately and was wondering if anyone can answer some of my questions on the Z450. I was wondering if anyone here has used any third party powders or binders and how you did it and how it turned out. Also does anyone know about the internal control circuits and where replacements can be found?

Thank you!

We only use 3rd party binder but 3d systems powered.

No one makes any internal board as most of them are custom.

The only one you can buy is probably the power supply and motors.

Www.cokreeate.com

That statement is confusing.
So you DO use 3rd party only or you ONLY use 3D Systems powder ?