Anet A8 3D prnter

Is there a way to test the X,Y and Z axis by them slves?

I also have a laud nose when I home the Prnter.

It look lke the X axis motor.

 check the limit swich, it check out good.

The problem is when the X axis get Home the lad noise starts.

 

Thanks

Frank G.

+1
0
-1

You can move the axis from the printer control panel

 

+1
0
-1

Thanks, I’ll try that, I am not home right now, but when I get back that the first I’ll try 

I try.

 

Thank

Frank G.

+1
0
-1

Thanks Kevin

I will download that prontface, at this 

point I could use all the help I can get.

3D printing is all new to me.

Thank you

Frank G.

+1
0
-1

Download pronterface. You’ll be able to control the printer much easier from this. 

Check your end stop switch again and make sure it’s in the right socket. 

Not the answer you’re looking for? Ask a new question to 485 ANET 3D experts active on Talk.

The 3D Printing Handbook is available now

If you’re a professional looking to master the key aspects of 3D printing, this book is for you.

The 3D printing handbook