Anycubic photon - Bed ahesion...working too well

I recently purchased a Anycubic photon and I'm really impressed with the printing quality.

 

I often had problems with prints not sticking to the bed in my old FDM times...however, with my brand new Anycubic photon I have another issue.

 

After leveling my Z axis following the instructions from the manual I produced multiple almost successful test prints. 

 

The problem I always encounter is, that it is almost impossible to remove the prints from the bed without using brute force (the removal tool provided with the printer is totally useless).

 

I'm worried about damaging my prints or the bed surface.

 

Does anyone have an idea how to get just enough adhesion for my prints to stick to the bed, but to be able to remove them in a normal fashion...?

 

Thanks!

Not the answer you’re looking for? Ask a new question to 66 Anycubic experts active on Talk.

The 3D Printing Handbook is available now

If you’re a professional looking to master the key aspects of 3D printing, this book is for you.

The 3D printing handbook