Feeder broke!

Help! I have a Qidi Tech 3d printer and the push release to remove the plastic filament rod from the feeder head broke. I patiently tried pushing it to release for about an hour but no luck. Then it finaly broke so now i need to get new parts. Not happy camper right now with Qudi Tech but hoping someone here can stir me in the right direction to getting this fixed. Here are two pics of the damage and thx for any help!

+1
0
-1

Hi, I do believe this is an excellent web site. I stumbledupon it ;) I am going to come back yet again since I book marked it. Money and freedom is the greatest way to change, may you be rich and continue to guide others. KODI ON ROKU

+1
0
-1

Not sure where you from. Normally you can buy them locally. Amazon also have sell. Just remember to bring the sample along when buy them to make sure the thread is match. Good luck :)

+1
0
-1

Hardware store or plumbing store or Amazon.  Common part.

 

Looks like you got pretty rough with it.  these a re a bit tricky to get to release but once you get it then it is easy.

 

You can probably still print fine the way it is.

 

Check in on the Facebook group QIDI 3D for additional help.

Not the answer you’re looking for? Ask a new question to 3447 3D Printer Parts experts active on Talk.

The 3D Printing Handbook is available now

If you’re a professional looking to master the key aspects of 3D printing, this book is for you.

The 3D printing handbook