New to 3D Printing

I picked up a CR-10 today and in trying to do the initial test print, my printer assumes my Z axis to be above the print bed, therefore nothing sticks, and the design becomes a quick mess. 

 

I have the upgrade kit for dual Z's, which I have installed. Also know I can't enter negative values for my axis, so...

 

What do I do??

+1
0
-1

To adjust the z hight on the CR-10, you have to turn the bed screws on the four corners. Use a piece of paper to find the correct hight between the nozzle and bed. If that doesn't work, try looking at the video I made about the CR-10 calibration at www.youtube.com/c/3DNow

 

Let me know if you have any questions!

Not the answer you’re looking for? Ask a new question to experts active on Talk.

The 3D Printing Handbook is available now

If you’re a professional looking to master the key aspects of 3D printing, this book is for you.

The 3D printing handbook