threed

TP
threed
@3dprinteruser
Member since

January 2017

15
Posts
#54
40
Comments
#199
4
Upvotes
#1299
Followed tags

threed isn't following any tags yet.

6 hours 18 min ago - Commented on What materials is better for functional prototyping?

+1
0
-1

Thanks. Actually the reason I plan to go for PLA only is that the fume is not as toxic as the ABS. How about the PETG?

2 days 14 hours ago - Commented on What materials is better for functional prototyping?

+1
0
-1

Thanks. What do you mean by "bake the PLA"? Putting it in oven?

2 days 15 hours ago - Posted a new Thread

5 days 11 hours ago - Posted a new Thread

1 week 2 days ago - Posted a new Thread

Hello, I read that 3D printers with an enclosure is better for health as they prevent the fume from spreading around the room. I cannot understand the validity of this statement because as soon as the user opens the door to take out the printout, the fume comes out from the printer and spread across the room. So, why having an enclosure is better for health?

2 weeks 5 days ago - Commented on Some questions for existing Raise's 3D N2 and N2 plus users

+1
0
-1

Thanks for the suggestions.

 

Which bondtech extruder are you talking about? Is there a model number? If I go for dual extruders, should I buy x2 the same item? There seems to be several for different printers but none for the Raise3D's.

 

If I only print PLA, is buying only the Hot End V2H Nozzle 0.4mm sufficient?

By "A spare hotend assembly may not be a bad idea either. ", do you mean Hot End Assembly (V2)?

 

In general, is it recommended to just use PLA or dissoluble one to build the raft? In the case of using dissoluble filament, which nozzle should I use?

 

2 weeks 5 days ago - Commented on Some questions for existing Raise's 3D N2 and N2 plus users

+1
0
-1

How is filaments from Hatchbox compared with those from Octave?

2 weeks 5 days ago - Posted a new Thread

Hello, I plan to buy a large volume 3D printer to use at home. Brand has not determined yet but most likely Raise3D N2+, Afinia H800+ (Up Box+) or Ultimaker 3 Extended. I read that even when printing using PLA, some kind of toxic particles are generated which could cause cancer. Any user has done anything to filter out those toxic particles? Pictures showing the setup would be nice.  

2 weeks 6 days ago - Commented on Ultimaker 3 Extended, Lulzbot TAZ 6, Raise 3D N2 and N2+ or Up Box+

+1
0
-1

N2+ is good but I cannot find a well ventilated place in my apartment to do the printing. How is the Ultimaker 3 Extended compared with the Afinia H800+ (aka Up Box+)? I

 

Do the Ultimaker 3 Extended, Afinia H800+ and TAZ 6 warn you before printing that the filament installed will not be enough to complete the job? Will they pause and allow the user to replace the filament and then restart from where it leaves off?

Pages