andrulonis

AA
andrulonis
@andrulonis
Member since

December 2017

8
Posts
#160
23
Comments
#401
0
Upvotes
Followed tags

andrulonis isn't following any tags yet.

2 hours 32 min ago - Commented on Clogging

+1
0
-1

then I will try 235 and then 230 and see if it is possible to actually print with this filament, maybe the producer wasnt raelly that sure about the temperatures or sth but if there are more problems i will definately post it

4 hours 15 min ago - Commented on Clogging

+1
0
-1

The thing is that the temperature of this ABS for printing is from 235-250 or 255 but the max temperature I can get with this printer is 240, wont this change also affect the print? I also have another problem that you can see below on the photo, is it also because it is too hot?

4 hours 33 min ago - Commented on Clogging

+1
0
-1

I have davinci pro 3in1 with XYZware Pro, I print on a glass bed with glue on it with ABS .

The same problem happened maybe twice but it was also with bigger prints only and that is the case here as well as it is fairly big print.

The printer is 1 year old.

I tried cleaning the nozzle by taking out filament and using the very thin metal thing that is made to fit the nozzle and is the same width as the hole in nozzle. It helps once and once it doesn't as after one cleaning like this the print came out very well but after one cleaning about 4 months ago when I was printing something big as well it still didn't help. 

For sure the model of print is not bad as now the print came out higher so that there were no problems like "at this specific point the problem occurs", it is simply random.

If any other information is needed then simply as if it would help

1 day 19 hours ago - Posted a new Thread

Lately I have been printing a figurine and after 1/4 of the print the proccess went on but the filament stopped flowing out and the nozzle was way above the print so it stopped at some point. There was no big clog on it, just the tip was a little covered so I cleaned it and started again (maybe it was because of uncleaned nozzle). Trying the same print, did 3/4   and the same thing happened.

2 weeks 6 days ago - Commented on Bubbles

+1
0
-1

apparently it wasnt maybe that is the case but if it is so, should I do something more with it?

3 weeks 2 hours ago - Commented on Bubbles

+1
0
-1

will definately try, how much do you suggest to change it?

3 weeks 2 hours ago - Commented on Bubbles

+1
0
-1

1. didnt really print the same but it sometimes happen and sometimes not but pretty much looks the same on those prints wehre there are vertical walls

2. once happens, once not, thats the weirdest part

3 weeks 1 day ago - Commented on Bubbles

+1
0
-1

increase speed as well? isn't it going to make it worse as it will be less accurate?

 

3 weeks 4 days ago - Posted a new Thread

Lately I noticed that there are some "bubbles" that you can clearly see on the photos below. How is that happening and how to take care of it?  

3 weeks 4 days ago - Commented on Weird problems

+1
0
-1

the msot curious for me are the bubbles, dont you know anything about them?

Pages