Alexis

AA
Alexis
@Arkinto
Member since

May 2017

1
Posts
#6471
2
Comments
#6020
6
Upvotes
#836
Hub Badges
Students program

View my Hub
Followed tags

Alexis isn't following any tags yet.

4 months 1 week ago - Commented on Stopped receiving orders

+1
1
-1

Hi thanks for the reply Nahla

I thought that might be a possibility and I didn't realise it affected my hub that much, in reality only 2 or 3 I had to decline due to not being able to print it and the others were sorted out with the clients for example they changed their minds or wanted it sooner and just left the order pending rather than cancelling on their side (which I assume they can do) so I cancelled the order on my side. Is there any way I can start getting orders again to fix this because I was doing really well with customers and prints and ratings?

4 months 3 weeks ago - Posted a new Thread

Hi there, I just have a quick query about my hub. I registered on 3D hubs a few months ago and was getting a couple of orders every few weeks, but now I have had nothing for around 3 months.

12 months 3 days ago - Commented on Almost ready to give up... Help!

+1
0
-1

If that's ABS then I believe your heatbed should be hotter (also as a note, ABS doesn't usually print well with open air printers).

Make sure your extruder is set to the temp is should for the ABS filament you're using. Some vary in recommended temperature.

I honestly think the default print surface is way better than glass or tape or pretty much anything apart from maybe PEI.

Try printing with a brim instead of a skirt and perhaps try printing a bit slower till you start getting solid prints again.

 

Also idk what slicer you're using or the profile you're using for that slicer, but I recommend Cura 2.5 or Simplify3D, try searching the internet for profiles people have already had success with. I recently got a Cocoon create Touch which is a Wanhao Dublicator i3 Plus rebrand and I have been comfortably using the default Cocoon create Touch default profile. They keep updating their website links since it's new but this link should have profiles for ABS and PLA: http://support.winplus.com.au/hc/en-us/articles/115002537203-CURA-Profiles-for-the-Cocoon-Create-Touch-HE161192

Going back one tab will take you to more information like filament temps, manuals, gcode sames etc...

 

Hope this info helps :)

1 year 1 week ago - Started following

1 year 1 week ago - Started following

1 year 1 week ago - Started following

1 year 1 week ago - Started following

1 year 1 week ago - Started following

1 year 1 week ago - Started following