Luca

LW
Luca
@black4hawk
Member since

October 2017

3
Posts
#719
5
Comments
#2410
0
Upvotes
Followed tags

Luca isn't following any tags yet.

1 month 3 weeks ago - Commented on Oozing in infill

+1
0
-1

Im using the newest version of cura. I dont want my nozzle to ooze, because it got caught on the print a few times. When i turn combing off, i get huge print times because of the long travels. 210°C gives me the best results with the plastic, otherwise i would tourn it down.

 

I just started a new print and now it looks good, i didnt change anything. Maybe its just how cura works ... D:

1 month 3 weeks ago - Commented on Anycubic Kossel Plus not stopping at bed

+1
0
-1

Do you use Cura? If yes, in the printer configuration, is 0 as middle checked? If not, do so!

1 month 3 weeks ago - Commented on ''heating failed Printer Halted please reset'' (Anycubic Kossel pulley version)

+1
0
-1

Do you have a heatbed installed? I had the same problem with the printer crashing after every print because my firmware was configured for a heatbed and I didn't have one.

1 month 3 weeks ago - Posted a new Thread

Hey, I recently installed everything on my pc freshly. I have some weird issues with my anycubic Kossel now. I print with primavalue Pla at 210C and 60 Heatbed, retraction is at 4.5mm and 60mm/s. The test files from matterhackers with the 4 cubes print flawlessly. I just have the problem that my nozzle keeps oozing in the infill during travel, which didn't happen before. Anyone any suggestions?

1 month 4 weeks ago - Commented on Kossel Print Failure

+1
0
-1

Hey, thanks for your input. Fans are all running. This was a two part print so the failure should show on the other part to, but it did not. I started a 0.2mm print and it went fine but failed later on. I'll try to unclog the nozzle, there may be some burnt PLA because I uses Asa before, maybe it didn't purge all.

1 month 4 weeks ago - Posted a new Thread

Hey community members, I started this X-Wing print on my Anycubic Kossel today: https://www.thingiverse.com/thing:909499 After 5 hours or so i noticed some heavy under-extrusion seen in the picture. The other party of this model was fine. Inside i noticed a lot of heavy, thick stringing.   I printed in PLA at 210°C/60°C, 45mm, 10mm retract at 25mm/s, .1 layers.  

2 months 1 day ago - Commented on Anycubic Delta Kossel - Pulley Version Printer Failure

+1
0
-1

Hey,
There should be a place mentioned in the manual with the firmware. I think you maybe have the wrong one, the one for the larger plus version. I use a other solution to auto level, there is a sensor with a limit switch and firmware for it on thingiverse, if you search for Kossel auto level.

3 months 1 week ago - Posted a new Thread

Hello 3D Hubs community, I'm new to the 3d printing game and own a anycubic Kossel. I quite like the idea of printing with large nozzle sizes for draft prints. Can I just screw in the volcano hot end and use it with the old cold end? I would buy this "eruption" pack.https://e3d-online.com/volcano-kits Thanks