Derek

DC
Derek
@DerCon0307
Member since

December 2017

1
Posts
#7420
2
Comments
#6226
0
Upvotes
Followed tags

Derek isn't following any tags yet.

6 months 1 week ago - Commented on Need some advice, please

+1
0
-1

I can move the head freely in all directions without power. I can move the feed motor also if I pull on the material. I’m sure that’s not good for it but when I get the random clogs and build ups it’s necessary. How do you adjust the driver current? 

 

Side note: I haven’t been able to actually connect the printer to my computer. I was able to get the slicer program that came with the printer ( I can’t think of the name of it now) to say that it was connected, although I wasn’t able to control the printer through the computer. Cura won’t recognize it at all. Not sure if if it’s me or the printer as far as that goes

6 months 1 week ago - Commented on Need some advice, please

6 months 1 week ago - Posted a new Thread