Electron

EA
Electron
@Electron
Member since

April 2018

1
Posts
#8100
1
Comments
#11585
0
Upvotes
Followed tags

Electron isn't following any tags yet.

6 days 12 hours ago - Commented on Anet A8 Printing problems

+1
0
-1

Yes i have auto-level on my printer and always check it before i print something, I will print the opposite of that  the right spool holder which is a mirror opposite of it. I will print it using default settings in cura at .2 layer height.

1 week 1 hour ago - Posted a new Thread

Hello. I have anet a8 I had purchased and assembled at the start of the week and i had received some printing problems but most of them have been resolved. All round the printer is good except for a few errors   When i was printing the stl file linked in the thread, I got these small gaps in the print as you can see, I am curious as to what can cause this.