George

GN
George
@georgeneamt
Member since

September 2017

1
Posts
#7053
5
Comments
#2459
0
Upvotes
Followed tags

George isn't following any tags yet.

9 months 1 week ago - Commented on ctc fdm 3d printer - SD Card content

+1
0
-1

Could you please tell me if the driver should go on the sd card that goes in the printer, or on the pc?

 

9 months 1 week ago - Commented on ctc fdm 3d printer - SD Card content

9 months 1 week ago - Commented on ctc fdm 3d printer - SD Card content

+1
0
-1

It worked so far but I will consider using cura.. I appreciate your help, I might contact you in the future for eventual issues, thank you!

9 months 1 week ago - Commented on ctc fdm 3d printer - SD Card content

+1
0
-1

I have I have a makerbot sw to print the files but will try cura.

I hope the driver will be ok.

My whole issue is that since I formatted the sd, when printing (it can also print with only a file-to-print on the SD card), the x axis is at moments changing its place and the objects get messed up. I don't know if it's the missing driver from the sd or another soft/hard problem..

9 months 1 week ago - Commented on ctc fdm 3d printer - SD Card content

+1
0
-1

so the driver is ch340 serial port interface, but what are cura and pronterface?

thanks for the answer!

 

9 months 1 week ago - Posted a new Thread

Hello! I accidentally formatted the SD card that came with the printer, and I would like to remake it. Can you please tell me what is the content of the card (and eventually upload an archive of the content)?   Lots of thanks!