Greg

GW
Greg
@GregoryWilets
Member since

November 2017

2
Posts
#1570
11
Comments
#982
4
Upvotes
#1321
Followed tags

Greg isn't following any tags yet.

7 months 1 week ago - Commented on Prints Stick Too Tightly To The Bed

7 months 1 week ago - Commented on Prints Stick Too Tightly To The Bed

+1
0
-1

Thank you for the idea. I'll keep working on this until it works.

7 months 1 week ago - Commented on Prints Stick Too Tightly To The Bed

7 months 1 week ago - Commented on Prints Stick Too Tightly To The Bed

7 months 1 week ago - Commented on Prints Stick Too Tightly To The Bed

7 months 1 week ago - Commented on Prints Stick Too Tightly To The Bed

+1
0
-1

Using Qidi X-One 2. PLA. Metal Manual Bed. Simplify3d. No additives. I have tried bed at 40 and 60 degrees.

7 months 1 week ago - Posted a new Thread

7 months 2 weeks ago - Commented on How do I make the interior of my prints solid?

+1
1
-1

Thank you for your help. You have made my day, if not my week. All is working well.

Greg

7 months 2 weeks ago - Commented on How do I make the interior of my prints solid?

+1
0
-1

I have loaded the STL file into S3D. The Qidi Tech One printer only prints with gcode. The Qidi software is supposed to convert the stl to gcode and then print. (I use a SD card since the Qidi software apparently does not support printing directly from a Mac).  I have been unable to accomplish that. Any other thoughts?

7 months 2 weeks ago - Commented on How do I make the interior of my prints solid?

+1
0
-1

I did not know you could convert a STL into a gcode/std to be printed by S3D when using a Mac. Could you explain how this is done? Thanks.

 

Pages