I recently installed everything on my pc freshly. I have some weird issues with my anycubic Kossel now. I print with primavalue Pla at 210C and 60 Heatbed, retraction is at 4.5mm and 60mm/s. The test files from matterhackers with the 4 cubes print flawlessly. I just have the problem that my nozzle keeps oozing in the infill during travel, which didn't happen before.
Anyone any suggestions?
Hey community members,
I started this X-Wing print on my Anycubic Kossel today: https://www.thingiverse.com/thing:909499
After 5 hours or so i noticed some heavy under-extrusion seen in the picture.
The other party of this model was fine. Inside i noticed a lot of heavy, thick stringing.
I printed in PLA at 210°C/60°C, 45mm, 10mm retract at 25mm/s, .1 layers.
Hello 3D Hubs community,
I'm new to the 3d printing game and own a anycubic Kossel. I quite like the idea of printing with large nozzle sizes for draft prints. Can I just screw in the volcano hot end and use it with the old cold end?
I would buy this "eruption" pack.https://e3d-online.com/volcano-kits