Nathan

ND
Nathan
@Nate_J
Member since

March 2016

1
Posts
#3878
4
Comments
#2894
0
Upvotes
Followed tags

Nathan isn't following any tags yet.

4 months 1 week ago - Commented on PETG printing with CTC

+1
0
-1

Thanks for the advice!

 

Does PETG absorb water similar to PLA when storing? I am using the esun 1.75mm PETG and I have had it for a few months. I tried printing with it back when I got it but ran out of time while trying to get all the kinks figured out. I am wondering if this may have caused some issues too.

 

4 months 1 week ago - Commented on PETG printing with CTC

+1
0
-1

The cube was 20mm x 20mm and the column was around 25mm in diameter. I will try that though. Thanks for the advice! I could see that being the case. Also, I take it that printing with PETG requires greater amount of infill due to its tendancy to be soft and glob if given the chance?

4 months 1 week ago - Commented on PETG printing with CTC

+1
0
-1

Here is a picture of the first print I had done with the PETG, I cut it in half to show the infill. This print came out good enough for what I would have needed. 

4 months 1 week ago - Commented on PETG printing with CTC

+1
0
-1

I had a 120mm fan with a PWM slowing it to half speed. I had the retraction set at 1.5mm.

4 months 1 week ago - Posted a new Thread