Sam

SC
Sam
@SamC_E
Member since

July 2017

1
Posts
#6774
1
Comments
#10873
0
Upvotes
Followed tags

4 days 12 hours ago - Commented on 3mm Filament Modification for Wanhao i3 Duplicator V2.1

+1
0
-1

Thankyou for the reply, could you clarify on a few bits please.

 

I am familiar with the microswiss all-metal, I have it running nicely on an i3 currently, when you say the 'arm' which part of the microswiss hot-end are you referring to? There are 3 pieces (Slotted i3 Cooling block, MK10 Thermal Barrier Tube, MK10 Nozzle), or do you mean the extruder arm that filament feeds through?.

 

What do you mean then by the 'parts' for the 3mm filament?

5 days 9 hours ago - Started following

5 days 9 hours ago - Posted a new Thread

Are there modifications I can make to the Wanhao i3 (such as replacing the extruder/hot end) to allow printing with 3mm filaments? Can anyone give specific 3mm components they know to run reliably with the Wanhao i3 please?   p.s. This is because I have a large amount of unused 3mm filament I would like to make use of.