Sam

SS
Sam
@Samschroeder13
Member since

April 2018

3
Posts
#768
1
Comments
#11808
0
Upvotes
Followed tags

Sam isn't following any tags yet.

1 month 4 weeks ago - Posted a new Thread

I am printer with my tevo tornado and I have been trying to print this large letter F for a long my time now and I keep having the same issue and I'm not sure what is causing it. The layers on the print are going from thick to thin on the initial few layers and once it gets to the Infill I have to stop it because it's not working.

2 months 4 weeks ago - Posted a new Thread

3 months 1 day ago - Commented on 3d printer problems

+1
0
-1

I appreciate the input and I had tried playing with a few settings here and there but after it failed for the 3rd time I decided to change a bunch of settings and as of right now it is turning out well. I slowed it way down to 30-40mm/s and changed to a smaller nozzle (just because)  changed the g-code flavor, layer height width and more.. I didn't really change the nozzle temp much however. Either way I'm just happy it's turning out now!!

3 months 2 days ago - Posted a new Thread

I am fairly new to 3d printing and I tried some southtech clear filament for the first time and I've had some problems with it and can't seem to figure out what is wrong (assumably with my settings). I am experiencing really stringy prints. The middle infill is alright but the walls arent turning out at all.