Ryan

RS
Ryan
@Sharpworks
Member since

December 2017

1
Posts
#7489
6
Comments
#1992
1
Upvotes
#5052
Followed tags

Ryan isn't following any tags yet.

4 months 3 weeks ago - Commented on [SOLVED] Anet A8 will not print on bed

4 months 3 weeks ago - Commented on [SOLVED] Anet A8 will not print on bed

+1
0
-1

Three names come up. What's your profile pic?

4 months 3 weeks ago - Commented on [SOLVED] Anet A8 will not print on bed

+1
0
-1

I fixed that a few minutes ago and I'm also installing Skynet and setting up cura 15.04.6.

4 months 3 weeks ago - Commented on [SOLVED] Anet A8 will not print on bed

4 months 3 weeks ago - Commented on [SOLVED] Anet A8 will not print on bed

4 months 3 weeks ago - Commented on [SOLVED] Anet A8 will not print on bed

+1
0
-1

I already have all of those settings but it still prints off the bed

4 months 3 weeks ago - Posted a new Thread

Print Settings for my Anet A8
[SOLUTION] First, my z axis end stop was too low, so I fixed it to be at the right height. I actually did that while installing Skynet by following this tutorial on the official GitHub. https://github.com/thijsk/Skynet3d I used Cura 15.04.6's Pronterface UI window to adjust the extruder to exactly the right height down to the 0.1mm and then set the end stop.