Hello. Yesterday i got my new cutted sized borosilicate glass from amazon for my monoprice mini delta. And i attached it to the bed and i usually heat the bed 60 degrees for pla and after few prints one of them really long one i cleaned the glass and as i felt it with my hands. It felt no longer flatted anymore with a really small mountains across the glass. I really need an explanation.
How do i attach the glass to the aluminium bed without making the bed wobbling/tilting in case i print something taller than about 8 cm height. This needs to be stablized really well so the weight of the glass and the print wont click the bed switchs and interrupt the leveling. Anyone has an idea.
today after taking out the sd card to load with print i tried to insert it again to the printer but the click mechanism stopped working which means the slot mutters the sd out as its not clicking to make it sit inside but everything else works about the sd card, it still reads it if i push the sd card witrh my finger inside but if i want to print now i need to keep it in with my finger the whole p
I have a question about the process used by tyler on youtube. If the printer has max z height it can reach so by adding a thick glass on the bed and using the printed part to adjust the bed inside the monoprice doesnt it decrease the zaxis height you can print in since you added a layer when the max height stays the same. Am i making any sense or someone can help me out understand it correctly.
and its awesome i learnt so much about it. at first i used to use the cura i got with the sd card provided ver 1.5.x something and it was almost perfect. the support was amazing it supported the print perfectly and it was really piece of cake to remove but then i got recommndation not related to use the newer version of cura and i tried it out.