Artie

AC
Artie
@SLArtie
Member since

November 2017

1
Posts
#7304
2
Comments
#6207
1
Upvotes
#5031
Followed tags

Artie isn't following any tags yet.

7 months 1 week ago - Commented on QiDi 3D Printer Adjustment

+1
0
-1

@wirlybird

Thanks for those linkies for replacement parts.

Anticipating using the 2nd option to minimize down time and sort out the "why" in due course.

Will revert with results.

7 months 1 week ago - Commented on QiDi 3D Printer Adjustment

+1
0
-1

@shahramrobotics-

Not a real good picture of the leak, I was trying to point out which extruder blk was loose.

Leak is actually hidden above the aluminum body up where it attaches to the rail assembly.

I did manage to slightly tighten the block but was concerned that the two head touching each

other would create undo heat/other problems.  Will give it a test run and monitor closely.

 

The filament flows well when temp is reached and the 1st layer raft lays down well.

7 months 1 week ago - Posted a new Thread

Hello all, I am using a QiDi Tech 3DP-QDA16-01 printer for work. Recently I have experienced a loose extruder body and a filament leak above the nozzle.   The printer lays down the first layer of the raft properly then there is hot filament coming from the back and up above of the extruder body. I am hesitant to tighten it until I can do this properly.