Stein

SG
Stein
@Stein_9
Member since

January 2017

1
Posts
#5546
2
Comments
#5651
0
Upvotes
Followed tags

Stein isn't following any tags yet.

5 months 1 week ago - Commented on Steppermotor Extruding

+1
0
-1

I will, thank you :).
I actually adjusted pretty much yesterday, from 100 to 145. But I will take the job again when I'm going to run filament all the way from the spool to the hotend.

What was a little annoying with the new firmware was that the resolution of the adjustment knot changed. It now adjusts to hundreds of parts.

5 months 1 week ago - Commented on Steppermotor Extruding

+1
0
-1

Hi guys.
I had also asked questions at Thingiverse, where I received an answer that I followed yesterday. The tip was to upgrade FirmWare into my machine. Until yesterday I had original FirmWare. Yesterday it could seem that the feed started to work again. I still do not understand why the feeding did not work after the reconstruction. This worked when the stepper motor was attached to the Extruder.

"gikam" I inserted a new original card to see if it was fault on my old one.

5 months 1 week ago - Posted a new Thread

Hello.I have an Anet A6 machine where I've got problems. I have rebuilt my machine to bowden and since my filament feeding is not working. My machine does not feed enough filament, no matter how much I adjust the parameter during configuration. I have switched the steppermotor twice (new motors) and have switched the mainboard.