Richard

RB
Richard
@User_4729
Member since

December 2017

4
Posts
#438
6
Comments
#1951
0
Upvotes
Followed tags

Richard isn't following any tags yet.

1 month 6 days ago - Commented on Y axis layer shifting

+1
0
-1

I'm using repeteir host and and it won't let uninstall slic3r. I then went to cura and sliced there it worked the fist time but only got half way through a test cube before stepping out of code then I tried it again and then repeteir wouldn't let me load the g codes so maybe a new operating software
PS I'm running the printer strait from the computer my 2004 lcd doesn't work

1 month 1 week ago - Posted a new Thread

My y axis is jumping back making my prints stair case the first layer goes down fine and it's consecutively jumping forward so I think there is something wrong with my slicer

1 month 1 week ago - Commented on Y axis layer shifting

+1
0
-1

Thank you that's a big help because I have no idea what's going wrong

1 month 1 week ago - Commented on Y axis layer shifting

1 month 1 week ago - Posted a new Thread

The problem I'm having is that the first few layers go down good but when I goes to print support is when it shifts (I think ) it's shifting about 10 to 15 mm need some help almost ready to start printing

1 month 2 weeks ago - Commented on Seeking heated bed help

1 month 2 weeks ago - Commented on Seeking heated bed help

+1
0
-1

Yes I have tested the mosfet and it runs it's self and the bed but when I plug it into the board the power drops. The power drops when I plug anything into the board terminals

1 month 2 weeks ago - Commented on Seeking heated bed help

+1
0
-1

The mosfet runs when I plug it up to the power supply and heats the bed it's when I plug the bed wires or the mosfet wires into the board is when the power drops. If I had a short where would it be

1 month 2 weeks ago - Posted a new Thread

So I've tried everything except solder the leads to the board but what's happening is that when nothing is in the heated bed terminals it runs 10v but when I plug the mosfet sig wires in the voltage drops to 2v and won't power the bed

1 month 3 weeks ago - Posted a new Thread

I have everything else working and my bed won't heat I tested the bed and it works off the 12 v supply With the wire to the heat bed unplugged the terminals on the board read 10 v when i put the wires in those terminals read 0 and thus not sending power to the bed The light for the heated bed works as dose the therest it cuts the light off when the bed comes up to heat Really need help I've looked