How do I take the nozzle off of my 3d printer

I have a Monoprice plus 3d printer. I was unclogging it with a drill bit but it broke off inside of the nozzle and I can't get it out. How do I take out the nozzle off of the printer?

+1
0
-1

Greetings,

Have question as well

 

I have a maker select v2. I used the supplied .4mm hand drill bit to clear the nozzle and it broke off inside the nozzle and now wont print well at all. I have tried disassembling the printer head but I can't get in to where the bit broke off. Does anyone have any tips? Or am I screwed and need to buy a new extruder?

+1
0
-1

go to your settings on the printer and preheat the nozzle to PLA temperatures, greater than 200 degC. Once it is there, you need to use a wrench and unscrew the nozzle from the heater block. Be careful since this is now HOT. If the drill bit is in there, you need to work fast before the PLA or what ever you are using sets and you can not remove the drill bit. It may be a good time to put a new nozzle in. At this time you should be able to push the filament that was stuck through the heater block to make sure nothing is stuck up higher. installing a the nozzle should also be done with the heater block at temperature.

+1
-3
-1

In any case, this admissions officer put it this way. Once you filter out the clearly unqualified, you're left with thousands of extremely well qualified applicants. I will do my essay homework about it

Not the answer you’re looking for? Ask a new question to experts active on Talk.

The 3D Printing Handbook is available now

If you’re a professional looking to master the key aspects of 3D printing, this book is for you.

The 3D printing handbook